Description
This close-coupled in-line pump has 2″ suction and discharge ports aligned within a cast iron casing and bracket. The hydraulic assembly includes a 6.15″ nominal diameter stainless steel impeller paired with a stainless steel shaft. The structure is rated for temperatures up to 250°F and is equipped with a seal consisting of a ceramic seat, carbon rotor, and EPT rubber. Its self-supporting design allows for installation in horizontal or vertical orientations without external strapping, while the aligned ports promote consistent fluid flow and minimize pipe strain.
The pump includes a 3 HP, 3450 RPM, ODP motor configured for 208-230/460V, 3PH power. Maintenance-free operation is supported by permanently sealed, grease-lubricated motor ball bearings. Utilizing a rear pull-out design, the assembly permits complete removal of the motor and rotating components for servicing without disturbing the connected piping layout.
