Description
This close-coupled in-line pump has 1.5-inch suction and discharge ports aligned to reduce piping strain. The casing and impeller use stainless steel construction, combined with a cast iron bracket and bronze wear ring. This self-supporting unit handles fluid temperatures up to 250°F and can be installed in horizontal or vertical configurations. The hydraulic assembly includes a 6.35-inch nominal impeller diameter and companion flanges. The internal seal uses a ceramic seat and carbon rotor with EPT rubber, built to Hydraulic Institute standards.
The pump uses a 3/4 HP, 1750 RPM, ODP motor, operating on 115/208-230V, 60Hz, 1PH power. Maintenance-free operation is supported by permanently sealed, grease-lubricated motor ball bearings. Utilizing a rear pull-out design, the assembly permits complete removal of the motor and rotating components for servicing without disturbing the connected piping layout.
