Description
Lock mortising attachment
Jig to be used with an electric drill to bore out a mortise to fit a door lock.
Application:
The jig is clamped onto a door to cut a mortise for the fitment of a door lock.
A drill is attached to the jig with the following requirements:
- The chuck needs to be removed to expose the 20UNF thread.
- The drill will be clamped on the collar ( 46mm).
- The drill will be part of the jig and will thus be a semi-permanent addition.
The cutting length and depth of cut can be adjusted to comply with the demands of various door lock sizes. The standard cutter supplied with the jig is a17mm.
We recommend using a drill with low speed torque. For example a rotary drill without percussion having 20 UNF thread.
Accessories and spare parts for the EG1:
- Grub screw M6x12mm
- Grub screw M6x25mm
- Handle bent
- Handle straight
- Hook
- Long guide pillar
- Long link
- Medium guide pillar
- Set of Vesconite bushes
- Shaft with 17mm MAD bit
- Shafts
- Short connecting bar
- Short guide pillar
- Short link
- Spare clamp bolt for clamp assembly
- Spare pressure pad with pin for clamp assembly
- Vesconite bushes long
- Vesconite bushes short
- Wood stand
- Allen key 6mm
- Bearings and bushes
- Castings – end pieces
- Casting – middle piece
- Casting – main body (H casting)
- Clamp assembly
- Clamp pad and bolt assebly
- Drill jig
Cutters for the EG1:
- 17mm cutter
- 19mm cutter
- 22mm cutter
- 25mm cutter
- 17mm MAD bit (shaft required for the MAD bit)
- TCT 17.15mm cutter
